DAWN ENTERPRISES INC.

9155 Sweet Valley Dr., Valley View, OH 44125

Phone: (216) 447-1777 or (800) 548-4867

Fax: (216) 447-3416

www.dawn-ent.com

 

INSTALLATION INSTRUCTIONS

PART NUMBER: SA-GS07

FOR: 2006 + Lexus GS300/GS350/GS460/

       GS350 Hybrid and GS430 (2006 only)

EFFECTIVE: 05.14.08

 

INSTALLATION PACKAGE INCLUDES:

A)      Alcohol Wipes

B)      Pro-Bond Adhesive Promoter (crush swab)

C)      Instruction Sheet

 

PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION
SELF-ADHERING INSTALLATION – NO HOLES TO DRILL

 

1.         CLEAN AND PREP

            For proper installation of Sportwing®, clean the surface where the Sportwing® is to be installed using the alcohol pads enclosed.  Wipe off any excess residue with a clean cloth.

 

2.         Close the trunk.  Starting on the drivers’ side, measure down 13  3/16” from the front corner of the trunk lid where it meets the window glass and make a mark.  See Diagram below.  Repeat procedure on passenger side.

 

3.         Leaving the Red Liner on bottom of mounting area of Sportwing®, place the Sportwing® so that it fits flush to the deck lid and the front tips of the Sportwing are aligned to the 13  3/16” marks that you made in Step #2.  Next, using a grease pencil and making sure Sportwing® is flush to the deck lid and in desired position, outline completely with the grease pencil around entire Sportwing® so that later on when adhering Sportwing® to the deck lid, you will be able to place the Sportwing® exactly to the desired position. 

 

4.         Next, using the Pro-Bond Adhesive Promoter, provided, squeeze the applicator until you feel the applicator crush.  The applicator will become wet on the end and is ready for use.  Apply the Pro-Bond inside of the outline marks of the Sportwing® that you made in Step #3.  Apply Pro-Bond where adhesive tape of the Sportwing® will adhere to the deck lid.  Next, make sure the vehicle and Sportwing® is at least 75°F/24°C (NOTE: if the surface of the vehicle and Sportwing is cold, use a heat gun or hair dryer to warm).  Peel the red liner off from the bottom of mounting area of Sportwing® and place back onto the outline marks on the deck lid made in Step #3 and press firmly into place.  Using a soft cloth, apply pressure the entire length of the Sportwing®.

 

5.         If you have any questions, problems or if you would like information about other quality Sportwing® products, please call the TOLL FREE number at the top of this sheet.  Thank you for choosing Dawn Enterprises Inc.